DriveCore Install Analog Series The new DriveCore" , Install series amplifiers is a complete line of high performance installation amplifiers based on Crown's proprietary DriveCore technology. ( nrl1300 Two-channel, 300W 0 4Q Analog Power Amplifier, 70V/100V compare -Gee-\\-ia .1)Ci 21600 (htt4/ Two-channel, mow O 4O Analog Power Amplifier; 70V/100V EFTA00594721 DCi 211250 2C131691/. Eight-channel, 600W O 4Q Analog Power Amplifier, 70V/100V compare „ s• Two-channel, 150W @ 4Q Analog Power Amplifier, 70V/100V ( compare DCi 411250 ( Four-channel, 1250W @ 4Q Analog Power Amplifier, 70V/100V compare Compare Selected Products Select 2 to 4 products to compare 62 EFTA00594722 Product Comparison --- , La. 47— pci 21600 (/en/oroducts/dci-2-600) Ven/prosLckcacitt® Product type Frequency Response ( 8 Ohms, 20 Hz - 20 kHz) Signal To Noise Ratio (A- weighted) Total Harmonic Distortion (at full rated power, 20 Hz - 20 kHz) Voltage Gain Damping Factor (20 Hz to 100 Hz) Input Impedance (nominal balanced, unbalanced) Maximum Input Level before Compression Maximum Input Level before Clipping Load Impedance Two-channel, 600W @ 4Q Analog Power Amplifier; 70V/100V +/- 0.25 dB > 108 dB 0.35% 34 dB >1000 10 kOhms, 5 kOhms +20 dBu +26 dBu 0.2 )( St.0.05 pci 20 250 Ven/oroducts/dci-2-1250) ) (Ledproducts/dcl-2-1250) Two-channel, 1250W @ 4Q Analog Power Amplifier, 70V/100V +/- 0.25 dB > 108 dB 0.35% 34 dB >1500 10 kOhms, 5 kOhms +20 dBu +26 dBu EFTA00594723 (Stereo/Dual 2 - 16 Ohms; 70Vrms and 100Vrms 2 - 16 Ohms; 70Vrms and 100Vm-is Mode) Load Impedance 4 - 16 Ohms; 140Vrms and 200Vrms 4 -16 Ohms; 140Vrms and 200Vrms Bridge Mono Cooling Continuously variable speed forced air, Continuously variable speed forced air, front to back airflow Maximum Fan Noise (re dBA SPL @ 1M) Required AC Mains (+/- 10%) HARMAN PROFEBSIONAL illeatimaga All Rights Reserved. 45 100V-240V - 50/60 Hz front to back airflow 45 100V-240V - 50/60 Hz AtLP\ EFTA00594724