From: "Jeffrey E." <[email protected]>

From: "Jeffrey E." <[email protected]> To: Eric Roth Richard Kahn Subject: Re: Preliminary for review Date: Thu, 22 Jun 2017 10:39:14 +0000 Inline-Images: image00 1 jpg; image002.jpg; image003.jpg and as the bulkhead is off we were going to pop in an upgraded tv On Wed, Jun 21, 2017 at 8:27 PM, Eric Roth > wrote: Stairs already selected and are in the process of being stripped. Covering plexi doors to conceal hutches already quoted. Best regards, Eric Eric H. Roth, President International Jet Interiors On Jun 21, 2017, at 8:25 PM, jeffrey E. <jeevacation®gmail.com> wrote: stair runner? all shade down switch. price for covering glass racks or removal in galley.. new leather above sink. ? not sure why this list took over a month to produce .. On Wed, Jun 21, 2017 at 5:49 PM, Eric Roth <1 I> wrote: Jeffrey, As per ow discussion a few minutes ago, I did not include the work TBD on the pocket door for the cabin side. CHANGE ORDER ITEMS REQUESTED 316 Fwd Lavatory Door $ 870 Design and fabricate a wood veneer overlay cover for the vacant / occupied sign to make it aesthetically blend in with the interior and not make it so conspicuously obvious. The cover will have one (1) hole that will display either color green (for vacant) or red (for occupied) and a thin EFTA01043005 horizontal slot for the lock override pin. 317 Fwd Crew Galley $ 15,780 Remove the existing hot water container and associated wiring. Modify the space to accept a customer supplied carry on small coffee maker (loose equipment). Relocate existing drawer if possible. All interior surfaces to be painted to match existing. Install new 110v 60Hz provisional outlet and associated wiring. 404 Hand Rails $ 4,820 Unfasten the cabin area PSU / valence assemblies to gain access to the wood veneered hand rails. Remove the hand rails from the PSU assemblies. Prep and cover the hand rails in the same ultraleather material as the PSU's to match. Reinstall newly covered hand rails and reinstall PSU assemblies. 412 Fwd Cabin Bulkheads $ 5,060 Remove the two (2) leather covered seat belt bumper pads. Template and fabricate thin kydex overlay panels. Cover panels in Hermes fabric to match the lower side walls. Remove and reinstall existing magazine racks (RIH has cabin temp sensor). Relocate any required placards and ash tray. 413 Fwd Cabin Door $ 420 Cabin Single Seats $ 18,190 Relocate the RIH #2 and UH #2 seats approximately 4.0"" aft to increase leg room. Install seat track as required including engineering and certification. Close off floor decompression blow out panel at RIH #3 seat position and install one (1) decompression blow out panel in the cabin area. Relocate the existing subwoofer from UH #3 seat position. EFTA01043006 423 Divan End Arm Cabinets $ 20,350 Design and fabricate light weight composite "sleeve" to fit over the four (4) existing end arm cabinets. Increase the height of the four (4) end arm cabinets by approximately 3.0" - 4.0". Angle the inside of each arm rest starting at the top of the bottom cushions as a decorative feature. Relocate existing Cabin Management Switches to the outboard side of the arm rests to create a clean inboard end arm(s). 503 Aft L/H Galley (Coffee Makers) $ 2,920 Remove the existing dual coffee makers from the upper galley area. Finish out area to conceal all non-essential wiring / plumbing / etc. Cap and stow existing electrical wiring and plumbing for the coffee makers. New interior surfaces painted to match the existing laminate. 503 Aft L/H Galley (Oven) $ 2,920 Remove the existing oven from the lower galley area. Finish out area to conceal all non-essential wiring / plumbing / etc. Cap and stow existing electrical wiring for the oven. New interior surfaces painted to match the existing laminate. 606 Aft Lavatory Potty Seat & Shroud $ 3,210 Laminate an additional .75' foam to the top of the potty seat for additional comfort. Laminate the potty seat deck with high gloss white high pressure laminate. Prep and paint toilet seat ring high gloss white to match new laminate. 611 R/H Aft Lavatory Closet $ 2,560 Modify closet by fabricating and installing a recessed cavity toilet paper holder. Inside of cavity will be laminated in wood veneer. Finish wood veneer in a high build finish. EFTA01043007 Best Regards, Eric ERIC H. ROTH I PRESIDENT ROI Logo - Horizontal - SMALL P Ic 2221 Smithtown Avenue, Long Island MacArthur Airport, Ronkonkoma, Ncw York 11779 please note The information contained in this communication is confidential, may be attorney-client privileged, may constitute inside information, and is intended only for the use of the addressee. It is the property of JEE Unauthorized use, disclosure or copying of this communication or any part thereof is strictly prohibited and may be unlawful. If you have received this communication in error, please notify us immediately by return e-mail or by e-mail to jea®gmail.com, and destroy this communication and all copies thereof, including all attachments. copyright -all rights reserved please note The information contained in this communication is confidential, may be attorney-client privileged, may EFTA01043008 constitute inside information, and is intended only for the use of the addressee. It is the property of JEE Unauthorized use, disclosure or copying of this communication or any part thereof is strictly prohibited and may be unlawful. If you have received this communication in error, please notify us immediately by return e-mail or by e-mail to [email protected], and destroy this communication and all copies thereof, including all attachments. copyright -all rights reserved EFTA01043009